4,500 DROPS, 10 FEET, 0% PHONE DAMAGE IN TESTING: A flexible TPU frame over a hard polycarbonate back, three layers deep, with a shock-absorbing airbag in each of the four corners. It holds 30kg pressed on one point and 120kg spread across the back, and it exceeds military-grade drop protection. CAMERA GUARDED, CAMERA CONTROL SEALED: The camera shelf is raised and closed around every lens, with a 3mm raised camera bezel and a 1.5mm raised bezel around the screen. Camera Control sits under a sealed part with an alloy frame and a 6-capacitive-stack PCB core, so click, slide and light-press all pass through it. 0 damage, 0 dirt, 0 delay. N52 MAGNET LOCK: A full ring of N52 magnets pulls the phone into place in one motion and holds a MagSafe battery pack, a card wallet, a car vent mount, a charging puck or a ring stand. Wireless charging runs at full speed straight through the case, so it never has to come off. HARD-COATED BACK, ANTI-YELLOWING: A white, skin-feel back panel under a very hard scratch-resistant coating, so it resists fingerprints, scratches and yellowing. The color sits in the opaque Deep Purple frame, and your phone reads softly through the back. Anti-slip stripes run down the side rails, and the side buttons stay covered rather than cut out, with a crisp click. FITS iPhone 16 ONLY: The iPhone 16, 16 Plus, 16e, 16 Pro and 16 Pro Max are five different bodies, so check yours under Settings, then General, then About before you order. Not silicone, so it slides out of a pocket instead of dragging. One CellEver Cybermag case in the box, no screen protector. The CellEver Cybermag case is built in two parts. The Deep Purple frame is opaque and carries the color, wrapping the sides and the camera shelf in a fine leather-grain texture with anti-slip stripes molded into the rails. Behind it sits a white, skin-feel back panel finished with a very hard coating that is baked on rather than laid over it as a film, so there is no edge to lift and nothing to peel at the corners. Your phone reads softly through it, the Apple logo stays visible, and the MagSafe ring is printed on the back in the frame color so you can see where the magnets sit. Camera Control is the part most cases settle for. A bare hole lets pocket grit reach a capacitive surface and a plain plastic lid dulls it; this one is a component of its own, with an alloy frame, a sealed face and six stacked capacitive layers carrying your fingertip through to the phone. Underneath everything there are three layers and an airbag in all four corners, because a dropped phone almost never lands flat. The materials are TPU and polycarbonate: flexible where the case has to give, rigid where it has to hold its shape. Every Cybermag shell is tooled for one iPhone body rather than stretched across a series, which is why the fit line on this page names a single model.