IMPORTANT COMPATIBILITY NOTICE: This distal end cutter is designed ONLY for thicker orthodontic wires from 0.014" to 0.019×0.025". NOT compatible with very thin flexible NiTi wires or wires below 0.014". Improper use on unsupported wire types may damage the cutting tip. IMPORTANT USAGE INSTRUCTION: Properly align the cutting edge with the orthodontic wire before applying pressure. Incorrect angle or twisting during use may bend the wire or damage the cutting edge. EASY TO CUT THE BRACES WIRE: If the braces wire pokes to your cheek at the end, this pliers is the solution. Just engage the wire and cut it in a second. When you use these pliers it will also hold the cut-off part and will not let it to injure the cheek. MORE VISIBILITY IN USE AND SOFT EDGES: The cutting area remains more visible because of its small cutting edges. The edges are smooth and will not hurt the cheeks or lips. EASY TO CLEAN: The 100% stainless steel construction makes the wire cutter easy to clean and they can be fully autoclaved without fear. It is a safe and hygienic choice for medical procedures. THESE PLIERS ARE NOT DESIGNED FOR THE CUTTING OF VERY THIN WIRES. WIRES LESS THAN 0.014" DIAMETER ARE NOT RECOMMENDED TO CUT WITH THESE PLIERS. Intended for cutting thicker orthodontic wires from 0.014" up to 0.019×0.025". Not suitable for very thin wires below 0.014" diameter or thin flexible nickel titanium (NiTi) wires used in initial stages of treatment.